SciCan Statim 2000 Betreibershandbuch PDF herunterladen (Seite 42)

8. Troubleshooting

Problem

Unit does not power ON.

There is water under the machine.

Instruments do not dry.

Check that water has not spilled when refilling the

reservoir. Make sure the plug in the exhaust tube is

secured. Remove and reinsert the cassette .

Attempt another cycle.

Be careful. The metal parts will be hot, and the cassette

will contain hot steam.

The cassette is leaking. If water drips from the

underside of the unit during operation, check the

cassette seal for misalignment or damage and replace

the seal if required.

Be careful. The metal parts will be hot, and the cassette

will contain hot steam.

Attempt another cycle. If it still leaks attempt another

cycle using a different cassette if possible.

If the leak persists, turn the unit OFF, remove and

unload the cassette, unplug the unit, and call

your dealer.

Solution

Check that the unit is plugged into a properly

grounded outlet and that the power cord is firmly

seated at the rear of the machine.

Try another circuit. Power unit OFF for 10 seconds

and then power ON again.

Check the condition of the line circuit

breaker or fuse.

Best drying occurs when the cycle continues to

completion. Allow the cycle to finish. Make sure the

instruments are loaded correctly in the cassette.

Refer to section 4.4 Preparing and Loading Instruments.

Check the unit leveling.

Check air filters and replace if dirty.

Clean the inside of the cassette and treat with Stat-Dri

drying agent. Refer to section 5.1 Cleaning the Cassette.

Examine the exhaust tube (tube to the waste bottle)

for kinks.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 48 49

Keine Kommentare

SciCan Statim 2000 Betreibershandbuch Seite 42