SciCan Statim 2000 Betreibershandbuch PDF herunterladen (Seite 29)

5. Maintenance

5.1 Cleaning the Cassette

Keeping the Statim cassette clean is good clinical practice and assists in the function of

the unit. SciCan recommends that the interior surface be cleaned at least once a week.

Use dishwashing soap or a mild detergent that does not contain chlorine. Scrub the

inside of the cassette with a cleaning pad designed for use with Teflon™ coated

surfaces. After scouring, rinse thoroughly with water to remove all traces of the

detergent. Cleaning the inside of your cassette is very important if you regularly sterilize

lubricated instruments. Coating the entire inside surface with STAT-DRI/STAT-DRI

PLUS drying agent induces water to form an even coat on the inside surface, without

beading. The water in contact with the hot cassette surfaces also evaporates much

more efficiently. Spotting is minimized and instruments dry much better. STAT-DRI/

STAT-DRI PLUS should be applied every 10 cycles, and after every cassette cleaning.

5.2 Cleaning the Water Reservoir Filter

The water reservoir filter should be cleaned at least once a week or when required. The

filter can easily be removed and cleaned by placing the filter upside down under running

water to wash away the particles until clean, and then placed back into the reservoir

opening. If a replacement water reservoir filter is required, order part number 01-109300S.

5.3 Cleaning the Reservoir

Check the reservoir for dirt or particles. The reservoir may be cleaned by draining

followed by cleaning and rinsing with steam process distilled water ONLY. Use of

chemicals or cleaning agents is not reccommended and could cause the unit damage.

5.4 Cleaning the Exterior Surfaces

Use a soft cloth moistened with soap and water to clean all exterior surfaces.

Do not use harsh cleaning chemicals or disinfectants.

5.5 Changing the Statim 2000 Air Filter

The filter should be replaced every six months in order to maintain an adequate supply

of clean air during the air drying cycle.

To change the filter, follow these steps:

1. Turn the power switch at the back of the unit OFF.

2. Remove and discard the old foam air filter

3. Install the new filter

(SciCan part no. 01-100207S).

4. Secure the filter plate

to the back of the

compressor using the screw

retained during

the disassembly procedure.

Figure 10

2000

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 48 49

Keine Kommentare

SciCan Statim 2000 Betreibershandbuch Seite 29